Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CW LMS 2.5 problem

My device display name always reset back to ip address.

This mean from Common Services>DCR i will always see device ip address instead of display name i have insert before.

3 REPLIES
Cisco Employee

Re: CW LMS 2.5 problem

Were the devices initially added to the DCR via IP address? Do they resolve properly forward and reverse via nslookup?

New Member

Re: CW LMS 2.5 problem

I've run into this issue before. I found that if the reverse lookup does not work, then I will only see IP addresses for the device names. You need to make sure that the IP address resolves to a name.

New Member

Re: CW LMS 2.5 problem

Thanks a lot and i will try

94
Views
4
Helpful
3
Replies