I am having some strange issues with SWIM under RME. In particular performing SW upgrades. The new version of RME will not upgrade code on a device unless TELNET is enabled as a transport method. So I enabled TELNET and it performed the upgrade and but I found that it used SSH to connect just as I had configured for the upgrade methodology. Anyway once the job said it was complete I checked out the device and SWIM had downloaded the .tar image to the device and the vlan.dat but it did not extract the .tar to flash, or set the boot parameters, or save the config back to flash. Any one had this problem? Looks like a bug.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...