Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CW LMS2.5 and Cat6509 with Native IOS

I recently upgraded my Cat6509 boxes to native IOS. Since the boxes are upgraded, LMS2.5 RME inventory collection has always failed to complete inventory collection on those boxes with native IOS. The error message is "Device is sensed, but inventory collection failed". I tried to delete the Cat6509's in DCR and let Campus Manager to discover them, and add them back in DCR. The result is still the same. My LMS2.5 is running with SP2. I didn't had any issues with those Cat6509's before when they were running hybrid codes (CatOS+IOS). What can I do to get the problem fixed? Thanks.

  • Network Management
1 ACCEPTED SOLUTION

Accepted Solutions
Red

Re: CW LMS2.5 and Cat6509 with Native IOS

Have you also installed RME 4.0 Service Pack 2?

There was a bug (CSCsa90532) in RME 4.0, but it is fixed in RME 4.0 Service Pack 2.

2 REPLIES
Red

Re: CW LMS2.5 and Cat6509 with Native IOS

Have you also installed RME 4.0 Service Pack 2?

There was a bug (CSCsa90532) in RME 4.0, but it is fixed in RME 4.0 Service Pack 2.

New Member

Re: CW LMS2.5 and Cat6509 with Native IOS

Thank you nhabib! I just upgraded to RME 4.0.2 and problem is solved.

105
Views
0
Helpful
2
Replies
This widget could not be displayed.