CW2.5.1 RME - Software Mgmt fails to reboot device
I'm running Ciscoworks 2.5.1 with RME 4.0.4 on Windows Server 2003 SP1.
On numerous Cat3500s and Cat4500s the software management in RME will successfully load the new IOS image and update the bootvar, but will always fail to reboot with the error code WIM5006: Device Reboot operation failed.
The device is not configured for reboot. The SNMP Write Community string might be wrong.
The command SNMP server system shutdown should be in the running configuration on the device.
However when I go to RME - Devices - Device Management - Device Credential Verification the test always succeeds.
I have tried modifying the RME SNMP timeout values, changing the SNMP timeout to 50 seconds and the SNMP retry to 4. From the same system I can always run snmpwalk on these devices with the same read-write string.
The errors from the full SWIM log are below, any help would be appreciated.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.