The integration of CWLMS 3.1 under Solaris 10, with ACS 4.2 (0) Build 124 Patch 9, was performed. All the CW modules were applied (Register all installed applications with ACS). Attached you will find the screen with the configuration after the integration (see image). It is correct the local ciscoworks authorization? Each user logged is always seen as help desk user, even when ACS is configured as system administration level. Is any configuration missing in CW? or depend on the ACS configuration?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...