Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Data Migration from LMS 3.0.1 (SA) to 3.1 (Master)

Hi All,

I have a data migration to perform. I was wondering if anyone has done, or has had any issues with, a migration from 3.0.1 (standalone) to 3.1 (master).

Cheers

David

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Data Migration from LMS 3.0.1 (SA) to 3.1 (Master)

It should work just fine. However, problems could always happen. After the migration, the DCR mode will be set back to standalone as the dcr.ini will be restored from the backup. You will need to reset it to master. In fact, I recommend you unregister all slaves from the master before doing the migration.

3 REPLIES
Cisco Employee

Re: Data Migration from LMS 3.0.1 (SA) to 3.1 (Master)

It should work just fine. However, problems could always happen. After the migration, the DCR mode will be set back to standalone as the dcr.ini will be restored from the backup. You will need to reset it to master. In fact, I recommend you unregister all slaves from the master before doing the migration.

New Member

Re: Data Migration from LMS 3.0.1 (SA) to 3.1 (Master)

Thx again Joe,

My intention was to recommend leaving the new server at Standalone; change it to Master after the migration. There are no other slave systems as yet (unless they wish to test beforehand).

I was curious about any gotchas and the like.

Cheers

Cisco Employee

Re: Data Migration from LMS 3.0.1 (SA) to 3.1 (Master)

No, no restore-specific gotchas. As with any big operation on Windows, I recommend disabling anti-virus software until after the operation is complete.

119
Views
0
Helpful
3
Replies