Hello I would like to know if i can install dcnm for red hat with X11 forwarding ,
X11 is working ,
but I can't lauch .bin
here the result:
sh dcnm-installer-x64-linux.6.3.2.bin Preparing to install... Extracting the JRE from the installer archive... Unpacking the JRE... Extracting the installation resources from the installer archive... Configuring the installer for this system's environment...
Graphical installers are not supported by the VM. The console mode will be used instead...
The valid UI modes identifiers are GUI, and Silent. By default installer will run in GUI mode. If you are running the installer in GUI mode, X windows resources should be available to display the GUI installer. It is not possible to telnet or ssh and install DCNM in GUI mode.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...