Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DCR - Unreachable Device polls stops working

Hi,

I have another issue related to the new feature called Device Poll

Device and Credentials - Admin - Device Polling - Device Poll Settings

I have settings going and the report once were fine for a day or so, but stopped suddenly to run.

Job browser show the job-id as "running"

no device are reported in Unreachable Device Report, since the job never finishes.

I have tried several different setting, like:

ICMP

ICMP+SNMPv2

SNMPv2

run time every 6 hours and every 24 hours ...

The servers are recently installed and patched.

Win2003 servers

Any ideas why this new feature isnt running ?

2 REPLIES
Cisco Employee

Re: DCR - Unreachable Device polls stops working

This problem has been reported before, but unfortunately, a resolution has not been found.  We need to see a full thread dump of the DCRDevicePoll process while the job is running.  Open a service request with TAC, and they can walk you through the process to get this output.

New Member

Re: DCR - Unreachable Device polls stops working

thank you very much for your reply.

165
Views
0
Helpful
2
Replies
CreatePlease login to create content