I'm new the SNMP so I realize this is probably a really dumb question but after racking my brains out figured it was time to ask for assistance. I have a stack of 3750x switches running the SNMP Server. It sends traps to my SNMP Manager (SNMPc). I've loaded the Cisco MIBs and (I believe) all the necessary dependecies, I've reviewed the MIBs and complied the Imports. For some reason, at least with my Cisco traps they come thru in the following format.
Comparing the above output to the traps from some of my other devices, such as APC which displays properly, I'm obviously missing something. For the life of me I can't figure out what I'm overlooking. The traps display properly in Solarwinds Orion so there's something I'm missing in SNMPc. Watched a couple of videos about walking a MIB but still don't understand how that works. If anyone could point me in the right direction would be greatly appreciated.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...