Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

delete fault and event syslog report - Prime LMS 4.2

Hi all

I created a fault and event report on my syslog data.  I run this report weekly.  I now need to change setting in that report but I'm not able to see where to edit this report. I see my job scheduled in the list but not able to modify anything.  Can someone help me on this

Thank you very much for your help.

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi ,Report must have a Job id

Hi ,

Report must have a Job id for that Job , you can delete it  via CLI :

1. Make note of the job ID's that you want to delete.

2. Open a dos shell and go to NMSROOT\CSCOpx\bin

3. Issue the command:

cwjava -cw NMSROOT com.cisco.nm.cmf.jrm.jobcli

3. It will take you to the Job CLI mode

4. Issue the command:

delete 1700  ( 1700 is the job ID , you wanted to delete)

5. Close all CiscoWorks browsers and issue the commands:

net stop crmdmgtd

net start crmdmgtd

6. Wait 15 minutes and log back in to CiscoWorks

 

hope it will help

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
4 REPLIES
Cisco Employee

Once the reports are created

Once the reports are created and scheduled , you can't edit them .

You need to create a new one with the changes you want and delete the other.

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Thanks.  But how can I delete

Thanks.  But how can I delete it.  I cannot even edit nor delete the report.

Thanks again :)

Cisco Employee

Hi ,Report must have a Job id

Hi ,

Report must have a Job id for that Job , you can delete it  via CLI :

1. Make note of the job ID's that you want to delete.

2. Open a dos shell and go to NMSROOT\CSCOpx\bin

3. Issue the command:

cwjava -cw NMSROOT com.cisco.nm.cmf.jrm.jobcli

3. It will take you to the Job CLI mode

4. Issue the command:

delete 1700  ( 1700 is the job ID , you wanted to delete)

5. Close all CiscoWorks browsers and issue the commands:

net stop crmdmgtd

net start crmdmgtd

6. Wait 15 minutes and log back in to CiscoWorks

 

hope it will help

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Thanks :)Had to know

Thanks :)

Had to know

76
Views
10
Helpful
4
Replies
CreatePlease login to create content