Detailed software reports Cisco Prime Infrastructure 2.0
We are running CPI 2.0. managing approximately 280 routers/switches. 2940's, 4900's 3700's and Nexus 5 and 7K's.
We have tried to run one type of software per device group where possible, but haven't fully succeeded.
I'm trying to find a away if possible of using CPI to carry out a report on the software versions per device group to see if there are any software advisories, end of support notices, compliance reports etc.
Does anyone know if this is possible, or what's the best I could hope for from CPI?
Thank you in advance for any information you can offer.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...