Is there any way of detecting high port errors (e.g. fcs errors) automatically, such as using cisco LMS, etc? instead of logging in to the switch and entering the command manually. As different IOS/CatOS and different model has different commands.
You could start with threshold monitoring of individual MIB variables onboard the switch/router using the "rmon alarm" and "rmon event" configuration commands. You can set rising and falling thresholds to send syslog messages and/or snmp traps. And no snmp polling bandwidth overhead on skinny WAN links. But you need a seperate "rmon alarm" config line monitoring each individual MIB variable.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...