Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Determine if Supervisor is V or IV with RME

I'm trying to run a report in RME that will show me what supervisor type my 4500 and 6500 devices are running. I've looked in Detailed Device Report and don't see it either. Any suggestions?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Determine if Supervisor is V or IV with RME

There may not be a clear indication of Sup type in the RME reports. RME reports on the SNMP object name of either the module type of the entPhysicalVendorType.

The Cat4K sup IV is cevCat4kWsx4515, and the Sup V is cevCat4kWsx4516.

2 REPLIES
Cisco Employee

Re: Determine if Supervisor is V or IV with RME

There may not be a clear indication of Sup type in the RME reports. RME reports on the SNMP object name of either the module type of the entPhysicalVendorType.

The Cat4K sup IV is cevCat4kWsx4515, and the Sup V is cevCat4kWsx4516.

New Member

Re: Determine if Supervisor is V or IV with RME

Good enough, I can work with that...thanks!

117
Views
0
Helpful
2
Replies