I'm very early in a LMS install/config and I've run into something confusing. Under Common Services -> Device and Credentials -> Device Management I have added three of my switches. However when I go to Device Troubleshooting -> Device Center the left column is a huge grey block with just "No Applications or Devices Found.." in the middle. But if I manually stick a hostname or IP in the box of one of the switches, it will pull up their info, and I can click on Cisco View and manage the device.
So clearly Device Manager saved the info about the switch because Cisco View is able to use the password & snmp info to connect.
So then why isn't it showing up in that left grey box?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.