Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Device configs are stale

How do I configure LMS 3.2 to periodically update it's knowledge of the device configuration?

Last week, I setup a poller to tell me whenever a router interface goes down.  HUM started reporting threshold violations on a few gre tunnels that were left over out on my network.  I went our to the router and remove the gre tunnel interfaces.  Yet, still HUM is reporting that those tunnels are down.

Is there a job that should be running periodically that will tell HUM that those interfaces no longer exist on the nextwork?

Everyone's tags (3)
3 REPLIES
Cisco Employee

Re: Device configs are stale

A thread should be running out of UPMProcess which detects ifIndex and ifAdminStatus state changes.  The logs are IfAdminStatus.log and UPMChangeDetection.log.  Check to see if you're seeing any errors in those logs.

New Member

Re: Device configs are stale

Sir,

Where do I find  IfAdminStatus.log and UPMChangeDetection.log?

Thank you,

TOd

Cisco Employee

Re: Device configs are stale

On Windows under NMSROOT\log and on Solaris under /var/adm/CSCOpx/log.

278
Views
0
Helpful
3
Replies