Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Device credentials problems

When we are adding a device in Ciscoworks LMS 2.5 that are running Tacacs we are experiencing problems with device credentials. When we are running a "Credential verification Report" we get "incorrect" in the "telnet" field and in the "enable by telnet" field we get "did not try"

Any suggestions on why this happends?

3 REPLIES
Silver

Re: Device credentials problems

Hi Martin,

please setup in "Common Services" -> "Device and Credentials" -> "Device Management" the access credentials for the devices.

Tick the group of devices or browse to the single device and then press the button "Edit".

A new windows appears. Follow the instructions and insert the matching passwords.

Your failure happens if no credential is setup. After the credential setup open the RME and run the report again.

Cheers

Frank

New Member

Re: Device credentials problems

Beware of TACACS it responds with PASSCODE, not PASSWORD. Passcode is not a valid response according to the doc I read.

Red

Re: Device credentials problems

The PASSCODE issue is resolved in RME 4.0.1 (see bug id CSCsa88849)

116
Views
0
Helpful
3
Replies