I have very important Cisco 2801 (revision 7.0) router and never discover by CW. when I log to the devices I can see the neighbor and alos when i log to the neighbor device also I can see this device as neighbor. also all the switches attached to this router also discovered by CW. when I checked on device center to this device also did not seen as neighbor. simply there is no recored as device or as neighbor about this device. the device not filtered out on discovery either. any suggestion...? how I can troubleshooting. Thanks
You can walk the cdpCacheTable on the device (and its neighbors) to verify CDP is correct from an SNMP standpoint. If it's Discovery that cannot find the device, make sure you have configured Discovery's hop counts to allow this device to be picked up. You might try starting a sniffer trace filtering on SNMP traffic to the device and its neighbors, then run a Discovery to see what Discovery polls on these devices.
could you please tell me how I can do these things.
You can walk the cdpCacheTable on the device (and its neighbors) to verify CDP is correct from an SNMP standpoint. regarding hop counts, I am using all DCR devices as seed device so no hop limitation. Thanks again for your time
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...