cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
378
Views
0
Helpful
1
Replies

Device Port Diagnostics in LMS 3.0

hashmatpaki
Level 1
Level 1

Dear All,

I am using Cisco LMS 3.0, how can I diagnose a port let say a switch port which has 8 pins and out of this 4 or 3 pins not working properly. for e.g. from 1,2,3 and 4, pin 2 has some fault, can I get this information from LMS. DFM will discover this info?

Thanks

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

No. This kind of layer 1 information cannot be diagnosed in LMS.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco