Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Device update

After patching my LMS 2.6 upto CM 4.0.10 (Solaris 9) I still observe some unwanted behaviour. When I change the name of a switch (also the DNS) this change is not recognized by Data Collection unless I delete such device and start a new network discovery cycle.

Is this normal in LMS 2.6? In LMS 2.2 this is updated automatically. Thanks

3 REPLIES
Cisco Employee

Re: Device update

You need to edit your DeviceDiscovery.properties file, and set at least one property to true:

nameserver.updateDCRDisplayName=true

If you want the DCR display name to update with the fully-qualified hostname, also make sure the following is set to true:

nameserver.updateDomainNameSuffix=true

After doing that, the display name should be updated in DCR when a change is detected.

Community Member

Re: Device update

It didn't work, even after restarting the LMS and launching a new discovery and data collection cycle again. Is there anything else I can try?

Cisco Employee

Re: Device update

Please post your DeviceDiscovery.properties file.

127
Views
0
Helpful
3
Replies
CreatePlease to create content