Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Devices in conflicting & suspended state

Hi Team

Devices are stuck in conflicting and suspended state.I am able to telnet these devices from LMS as well as it is also showing in RME.

We are getting this error while clicking on any device.

Regards

Vaibhav

1 REPLY
Cisco Employee

Re: Devices in conflicting & suspended state

Are the devices suspended or conflicting? Go to RME > Devices > Device Management > Suspended Devices and Conflicting Devices, and see if the devices are listed there. For Suspended Devices, resume them. For Conflicting Devices, you will need to adjust the DCR device type to match the actual device type being managed. It is recommended to leave the DCR device type as Unknown so that the applications can figure out what type of device it is.

125
Views
0
Helpful
1
Replies