Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Devices steel in learning mode in DFM LMS 2.5

Hallo

I have also the problem.
All my device steel in learning mode.

This is my version LMS:
LMS 2.5


CiscoWorks Common Services 3.0.3
Campus Manager 4.0.3
CiscoView 6.1.2
Device Fault Manager 2.0.3
Integration Utility 1.6.0
Resource Manager Essentials 4.0.3

I try to change the poling configuration in DFM and I received this message.

Could not retrieve current data since the PTMServer process is down.

Please restart the process and perform this operation again.

But the PTMServer is running

thanks

2 REPLIES
New Member

Re: Devices steel in learning mode in DFM LMS 2.5

Cisco Employee

Re: Devices steel in learning mode in DFM LMS 2.5

LMS 2.5.1 is very old, and will no longer be supported after June of this year.  I strongly suggest you upgrade to LMS 2.6 with DFM 2.0.13 before going further.  LMS 2.6 can be downloaded from http://tools.cisco.com/support/downloads/go/Redirect.x?mdfid=268439477 , the Common Services 3.0.6 update (to be applied after 2.6) from http://www.cisco.com/cgi-bin/tablebuild.pl/cd-one-3des , then DFM 2.0.13 can be found via Common Services > Software Center > Software Update.

280
Views
0
Helpful
2
Replies