cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
756
Views
5
Helpful
1
Replies

DFM 2.0.9 Polling control

rgomes
Level 1
Level 1

A customer asked me if it's possible to control the way DFM detects the threshold crossing. On several NNM it's possible to say X crossing occurrences on Y polling cycles, or X consecutive crossing, etc. As there are no details on the docs I am assuming that the algorithm is straight, one crossing triggers an event.

Is there any hidden file where we can change this behavior?

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

You are correct in your analysis. While DFM gives you the ability to set the thresholds, you cannot control the algorithm used to compute the events.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco