Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1089
Views
0
Helpful
2
Replies

DFM alert

ciscoforum
Level 1
Level 1

‎01-26-2006 08:40 PM

LMS2.5. I noticed that DFM will send all the interfaces up and down alerts when it polls. How can I make it just send alert for one particular interface? For example I just want to monitor the wan interface, not vlan interface, not lan interface. But when add the device wan ip into common service and shows in the DFM, even the loop or lan interface down, it also will send alerts. Is there a way to avoid this? thaks

Labels:
0 Helpful
2 Replies 2

wdrootz
Level 4
Level 4

‎02-01-2006 02:24 PM

the alerts configured on DFM or device based, don't think, you can configure them specific to an interface.

0 Helpful

nategreer
Level 1
Level 1

‎02-13-2006 08:57 AM

Go into device details and look at the interfaces or ports. You should be able to set the Managed State to False.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents