Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

DFM alert

LMS2.5. I noticed that DFM will send all the interfaces up and down alerts when it polls. How can I make it just send alert for one particular interface? For example I just want to monitor the wan interface, not vlan interface, not lan interface. But when add the device wan ip into common service and shows in the DFM, even the loop or lan interface down, it also will send alerts. Is there a way to avoid this? thaks

2 REPLIES
Bronze

Re: DFM alert

the alerts configured on DFM or device based, don't think, you can configure them specific to an interface.

New Member

Re: DFM alert

Go into device details and look at the interfaces or ports. You should be able to set the Managed State to False.

115
Views
0
Helpful
2
Replies
CreatePlease to create content