Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DFM Alerts - High Utilization

I occasionally get High Utilization alerts, and was wondering if there was a way within LMS to actually look the exact traffic that is causing these high utilization alerts? I looked that the packet capture funtion in device center, but it only allows me to specify ports, ip address, etc., not specific physical interfaces. These alerts are usually in another building, so I don't always have the time to go over there and possibly mirror the port and do a packet capture. Any other ideas out there?

Thanks

1 REPLY
Cisco Employee

Re: DFM Alerts - High Utilization

Since this traffic is passing through the devices, you will need a remote network probe or sniffer. Something like the Network Analysis Module or ISR routers or 6500 switches would work, as would any distributed sniffer or RMON switch probe. None of these are included with LMS.

126
Views
0
Helpful
1
Replies