DFM and interface status?

[marktop2]

Hello,

I have the following problem with DFM 2.0.2 on Windows:

After initial successful discovery in CM I get many alarms: "interface unresponsive", although "admin state" of relevant interface is "down".

I guess the expected behaviour should be to ignore such interfaces (administrativly down - shutdown) regardless of state of line protocol.

Once suspended/resumed/cleared the alarms reappear again and again.

Questionable interfaces are serial interfaces on 2600/3600 router.

Thanks for answer

Mark

[wong34539]

Try deleting the devices and then re-add the devices.

[marktop2]

Thanks for answer!

I did deleting and rediscovery already, just the same result!

Any more ideas?

Thanks

mark