Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

DFM - Default Thresholds value

Dear all,

Does someone has a document listing all default threshold value on Device Fault Manager (DFM) of LMS ?

Particularly, I need to know the thresholds for :

- Interface HighUtilization alert, and

- Interface HighQueueDropRate.

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: DFM - Default Thresholds value

Utilization: 40 %

Queue Drop Rate: 1%

4 REPLIES

Re: DFM - Default Thresholds value

DFM defaults:

Backplane utilization threshold 80 %

Memory buffer miss threshold: 10 %

Free memory threshold 15 %

Memory fragmentation threshold 5 %

Memory buffer utilization threshold 90 %

Processor utilization threshold 90 %

You can check the default settings for thresholds

DFM > Configuration > Polling and Thresholds > Managing Thresholds

There you can choose from the default groups, and look for the group where you got the HighQueueDropRate from, if its for example and 10-100 Mbit eth interface, than you should go to Interface Groups, 10MB-100MB Ethernet group, and click EDIT.

New Member

Re: DFM - Default Thresholds value

Hi Lucien,

Thanks for prompt reply.

I saw these thresholds related to device performance but not interface.

Do you have values for 100 Mbps Ethernet:

- Interface HighUtilization

- Interface HighQueueDropRate.

Thanks.

Re: DFM - Default Thresholds value

Utilization: 40 %

Queue Drop Rate: 1%

New Member

Re: DFM - Default Thresholds value

Many thanks Lucien.

Much appreciated.

159
Views
5
Helpful
4
Replies
CreatePlease to create content