Does anyone know if is possible to customize the email alerts sent by the DFM?
I am configuring the server to send email alerts to my cell phone but my cell phone is not able to receive the complete message via sms (I only receive the first 3 lines of the message) so I was wondering if its possible to customize the email alert sent by the DFM to send the IP address of the device and the event description.
DFM 3.0 is part of LMS 3.0. It is not available for download. You must purchase LMS 3.0. Until the end of October, there is a 40% discount for those customers that already own a contract on LMS 2.5 or 2.6.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...