Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DFM - Power supply fault

good morning! I wish to do a foolowing question: is it possible display on alerts panel any trap received after a power supply fault? And, if yes, which configuration have I do?

Thanks in advance

Best regards

Alberto Malatesta

2 REPLIES
Cisco Employee

Re: DFM - Power supply fault

DFM is not a general purpose trap receiver, and will only process and/or display a small number of traps (none of which relates to power supply failures).

However, DFM will poll certain devices for PS failures. It just depends on your version of DFM, and the device in question. If DFM is able to detect a fault in a power supply, that fault will be displayed in DFM's Alerts and Activities Display.

New Member

Re: DFM - Power supply fault

I have a datacenter with 2 switch Catalyst 4507 e 2 router 7206VXR (to connecting via WAN small offices). The version of DFM is 2.0.6. Is DFM able to detect? I have made some tests but I haven't seen coming no message. In the case, can you suggest how have I configure DFM?

Thanks in advance

Best regards

140
Views
0
Helpful
2
Replies