Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

DFM: when does the "Alert ID" change for a device?

If an Event occures for device_A a corresponding Alert-ID x is generated. All Events for device_A are grouped together under this Alert-ID x.

Is there a corresponding time window in which all incomming Events for device_A will be grouped under this Alert-ID x or - if generated once this Alert-ID x is bound to device_A for eternity? (or just until the next restart of dmgtd?)

Does anybody know the sense behind these not rememberable Alert-IDs which are also useless for Notification Services?

The only thing I found was this:

========

Terminology has changed since DFM 1.2.x as follows:

•Symptom is replaced by event. Events are rolled up into alerts.

•Compound is not used and there is no replacement. A compound differs from an alert; there could be multiple compounds on a single device, whereas an alert is a roll-up of all events for a device.

=======

from this Install Guide:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_device_fault_manager/2.0_IDU_2.0.6/installation_solaris/guide/newNav.html#wp1014226

  • Network Management
1 REPLY
Cisco Employee

Re: DFM: when does the "Alert ID" change for a device?

All events will be rolled into one alert as long as the alert stays active. Once the alert clears, and is moved to Fault History, then a new active event will create a new alert.

No, there is no significance to the Alert IDs. In fact, I typically recommend to customers not to do any notifications of alerts since events have all the juicy details.

114
Views
0
Helpful
1
Replies