DHCP server on Cisco 2600 ios 12.0(7)T release same address
I have configured a 2600 as dhcp-server with this configuration:
username AccountRemote password PasswordRemote
ip dhcp excluded-address 10.8.0.1 10.8.0.200
ip dhcp pool RasPool
network 10.8.0.0 255.255.255.0
ip dhcp-server 10.8.0.127
ip address 10.8.0.127 255.255.255.0
ip nat inside
no ip address
dialer pool-member 1
isdn switch-type basic-net3
ip unnumbered Ethernet0/0
ip nat inside
dialer remote-name AccountRemote
dialer pool 1
peer default ip address dhcp
ppp authentication chap
Well. When the router receive an IDSN callin, release an address (i.e. 10.8.0.201). If, when the first callin is ON, the router receive a second ISDN callin it release the SAME address 10.8.0.201 of the first connection.
Re: DHCP server on Cisco 2600 ios 12.0(7)T release same address
the problem is that the users are not routers but PC with isdn-modem and I cannot be sure that nobody uses differents PC with the SAME username. It its happens, the second connection does'nt work but ALSO the first go in bad run (same remote address at 2 differents end-point). Why the IOS doesn't recognize that the address is used in the previous connection?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.