Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Disable Alarm/Event on CPI 2.0

Hi,

We have CPI 2.0 in production. and overwhelmed interface down/up alrms from access switches are annoying. Is there a way to turn it off, I believe it is on by default.

Thanks

1 REPLY
Cisco Employee

Disable Alarm/Event on CPI 2.0

Hi Tao,

I don't think , we can completely turned off the Alarms. if there is any device or a list of interfaces  for which you are concerned , then I  would suggest to change that interfcae status to ADMIN down  in PI to avoid getting alerts.

check if that help you

"Under Lifecycle Theme, go to Device Work Center Select the device.
Under the Configuration tab, select Interfaces.
Select the interface and click on Disable. This allows you to select the interface and click on disable which also puts the interface in the Administratively Down state "

Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
84
Views
0
Helpful
1
Replies