Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Disable Port Link State Logging

Hello,

I have a Catalyst 3560 configured to send syslog messages to a syslog server.  This switch has a host plugged into one of its edge ports which resets its link state every 20 minutes (due to an intentionally configured 20-minute restart interval).  I'd like to turn off the logging of this (and only this) specific event.  I wasn't able to have much luck with searching.

Any guidance would be appreciated.

Thanks,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Disable Port Link State Logging

Under the interface configuration for the port, add these two commands:

no logging event link-status

no snmp trap link-status

1 REPLY
Cisco Employee

Re: Disable Port Link State Logging

Under the interface configuration for the port, add these two commands:

no logging event link-status

no snmp trap link-status

1919
Views
0
Helpful
1
Replies
CreatePlease to create content