Check to make sure you do not have an SNMP access-list applied to that community string in the config. If you do make sure the IP address of the CiscoWorks server is allowed by the ACL. Next, make sure there are no firwewalls or other ACLs between the LMS server and the switch which could be blocking SNMP. You can run debug snmp packet on the switch to see if the SNMP requests are actually making it.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...