DSP total Channels/active channels not returned properly on SNMP
I did a SNMP walk on a AS5400XM MediaGateway for getting the number of total number of DSP channels available as well as the active DSP channels in it.
We were using OID 18.104.22.168.22.214.171.124.126.96.36.199.1.8 for DSP Active Channels and 188.8.131.52.184.108.40.206.220.127.116.11.1.6 for DSP Total Channels. For total channels we are getting 56 indexes with 16 as value for each, so ideally the count comes to 896 only but there are 16 64-channel DSP cards, which is 1024 channels and "show voice dsp summary" also shows that there are 1024 channels available. The same does happen for Active channels too, we are getting 56 indexes only. If we get 64 indexes then we will be getting 1024 channels.
Do let us know if we are missing something or do we need to configure anything on the device to give proper value on SNMP.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...