Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dummy access-list in ACLM 1.6

ACLM 1.6 create dummy access-list with one statement:

permit tcp host <ACLM-ip-address> any range 22 23

Then ACLM applies this dummy acl on interface and removes the oryginal acl.

When dynamic routing is configured through this interface, connection between ACLM and router fails because dummy access-list does not contain permition for dynamic routing.

Question:

Can I modify the contents of dummy access-list from ACLM Manager level and add permit eigrp any any statement?

I can't add static route on router; there are other

backup dynamic routings with different administrative distance.

How to use ACLM to change access-list applied on interface with dynamic routing

( ACLM is communicating through thist interface) ?

Could anyone help me to solve this problem?

1 REPLY
Silver

Re: Dummy access-list in ACLM 1.6

You should find the following document useful which explains how to configure ACLM and configure the ACLM. I am sure this document answers to your queries.

http://www.cisco.com/en/US/products/sw/cscowork/ps402/products_installation_guide_chapter09186a0080202670.html

132
Views
0
Helpful
1
Replies