Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

DXX issue

any one help me about this matter.

I have DXX link b/w my two node. one is Head office and one is Branch.

when I use show int serial1/0 I have receive

Serial is up and line Protocol is up at both end and data transfer is also fine no problem.

But DSR which i highlighted is showing Down. What is this problem?

I can't understand any one define me.

RouterXYZ>show int se4/4

Serial4/4 is up, line protocol is up

Hardware is CD2430 in sync mode

Description: - 64k DXX Link......

Internet address is 10.X.X.X/30

MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,

reliability 255/255, txload 3/255, rxload 3/255

Encapsulation HDLC, loopback not set

Keepalive set (10 sec)

Scramble enabled

Last input 00: 00:00 , output 00:00:00, output hang never

Last clearing of "show interface" counters 2w6d

Input queue: 0/75/0/0 (size/max/drops/ flushes); Total outp

Queueing strategy: weighted fair

Output queue: 0/1000/64/4 (size/max total/threshold/ drops)

Conversations 0/29/32 (active/max active/max total)

Reserved Conversations 0/0 (allocated/max allocated)

Available Bandwidth 48 kilobits/sec

5 minute input rate 1000 bits/sec, 2 packets/sec

5 minute output rate 1000 bits/sec, 1 packets/sec

2989857 packets input, 259973705 bytes, 0 no buffer

Received 210049 broadcasts, 0 runts, 1 giants, 0 thrott

164 input errors, 58 CRC, 0 frame, 0 overrun, 0 ignored

2645960 packets output, 393415097 bytes, 0 underruns

0 output errors, 0 collisions, 198 interface resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions

DCD=up DSR=down DTR=up RTS=up CTS=up

165
Views
0
Helpful
0
Replies
CreatePlease to create content