I have a Cisco Prime Infrastructure 2.1 with almost 100 switches registered and managed properly. I have configured the Mail Server and alarm notifications are sent with no problems.
The deal is that I don´t want to recieve alarm mails for every single device that is registered. Is it possible to recieve mails just for a group of devices? I was checking the Cisco documents but could not find something clear about this.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...