Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Enable debugging for a running CSDiscovery process?

I've got problems with a discovery process that will not finish after discovering most or all of the devices . Around 6000 devices will be discovered. When I enable debugging (Discovery Framework) beside the fact that the log file will be quite large the process runs for days.

As I expect the failure to be at the end of the discovery process, is it possible to enable debugging just at the end (around 5500 devices) ? When I enable debugging a pop-up states that debugging will be activated in 60 sec, but will the currently running CSDiscovery proceess fully account for these settings?

1 REPLY
Cisco Employee

Re: Enable debugging for a running CSDiscovery process?

No. This problem has been plaguing us for a while. The only way to isolate it will be to enable framework debugging for the whole Discovery, then get a full thread dump when the process has locked up. The problem appears to be a thread that dies unexpectedly.

106
Views
0
Helpful
1
Replies