Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

enable netflow on WS-6509

Hi guys,

I am not able to capture all the traffic on a 6509 Router. It runs the followign software..

IOS (tm) c6sup2_rp Software (c6sup2_rp-PK2SV-M), Version 12.1(23)E4, RELEASE SOFTWARE (fc1)

The configuration changes that I made are..

(all ip address are changed for security reasons)

# Global commands in configuration mode

ip flow-export source Loopback 0

ip flow-export version 5 peer-as

ip flow-export destination xxx.xxx.xxx.xxx 9065

ip flow-cache timeout active 1

# Configuration change on each interface

ip route-cache flow

following are the interefaces that I want to capture traffic.

Current configuration : 163 bytes

!

interface FastEthernet9/46

description Public Side VPN-NET

ip address xxx.xxx.xxx.xxx 255.255.255.248

ip access-group vpn-public out

ip route-cache flow

end

!

interface GigabitEthernet1/2

logging event link-status

load-interval 30

switchport

switchport access vlan 888

end

!

interface Vlan888

description Firewall Outside

ip address xxx.xxx.xxx.xxx 255.255.255.240

no ip redirects

no ip unreachables

no ip proxy-arp

ip pim sparse-mode

ip route-cache flow

logging event link-status

load-interval 30

end

Please let me know if you guys need any additional information. Any pointers towards a solution will also be greatly appreciated.

Thanks,

Prakash.

1 REPLY
Silver

Re: enable netflow on WS-6509

check out the following link for configuring netflow on Catalyst 6500 :

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a2b.html

hope this helps.

202
Views
0
Helpful
1
Replies