When I use Report generator from Campus User Tracking to run report on End Hosts with All Host Entries option, the report doesn't display ip & hostnames of endhosts connected to switches, shows only mac-address which I assume are the host mac-addresses and not the switch interfaces' mac-addresses. Our switches are running at layer2 and routing is provided by the FW. Is there any way ip & hostnames can be displayed when I run report? We are running LMS3.1
Unfortunately, firewalls are not supported by Campus Manager since they do not support CDP. This means that UT will not be able to use them for obtaining ARP data.
What I have done as a workaround in my lab is to create a shadow router which sits next to the firewall. This router isn't really routing. All it does is collect ARP entries, and sends ICMP redirects for the firewall. All of the hosts on that VLAN point to the shadow router for routing, but are really routed by the firewall. It's not the prettiest workaround, but it will allow you to see layer 3 information in UT.
I use an old 2500, but any support Cisco router will work.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...