Hi, I developed the energywise module on IOS4ALL (www.ios4all.net) to provide a simple Windows GUI to configure it on switches.
Now the module have basic features but I want to improve it with a centralized management of energywise for all switches in a site.
Is possible only with switches "energywise capable" run query over other switches? By assigning the same domain and password can I run a query on a switch with some keywords and have as a scope the entire switch network?
For example query like:
energywise query importance 100 keywords phones set level 0
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...