Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

error message when trying to use config editor

I received the following error message when trying to deploy the changes to the device:

CEDT0031: no command is available to download for the device X.X.X.X. REmove the device from the job and try again.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: error message when trying to use config editor

You can't do that.  Instead, just remove "aaa new-model" from the config then try to deploy it.  Alternatively, you can try "merge mode," but that will send the whole config back to the device.

3 REPLIES
Cisco Employee

Re: error message when trying to use config editor

What mode are you selecting (merge or overwrite)?  What exactly was changed in the configuration?

Community Member

Re: error message when trying to use config editor

overwrite command. I was trying " no aaa new-model" command.

Cisco Employee

Re: error message when trying to use config editor

You can't do that.  Instead, just remove "aaa new-model" from the config then try to deploy it.  Alternatively, you can try "merge mode," but that will send the whole config back to the device.

192
Views
0
Helpful
3
Replies
CreatePlease to create content