Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Etherchannel issue between 3750 stack and WS-CBS3012 for IBM blade centre

Hi,

We are trying to configure Etherchannel between four ports of cisco 3750 stack(2ports from one switch of stack and two ports from another switch of same stack). We are facing issues with this setup. The ports in WS-CBS3012 are going to err disable mode.

Is  there any limitations associated with such a cross-stack etherchannel configuration. Please suggest if there is any particular sequence of configuration involved.

Switch1 in stack

int gi 3/0/3

switchport mo trunk

switchport trunk allowed vlan 10-30

sw tr en dot1q

channel-group 1 mode on

spanning-tree guard root

switch 2 in stack

int gi 3/0/3

switchport mode trunk

switchport trunk allowed vlan 10-30

sw tr en dot1q

channel-group 1 mode on

spanning-tree guard root

int port-channel 1

switchport mode trunk

switchport trunk allowed vlan 10-30

sw tr en dot1q

channel-group 1 mode on

spanning-tree guard root

in WS-CBS3012 ports are configured with trunk,allowed vlan and etherchannel configuration with mode on.

With Regards,

Madhan kumar G

1 REPLY
New Member

Etherchannel issue between 3750 stack and WS-CBS3012 for IBM bla

Hi,

The commnad "no spanning-tree etherchannel guard misconfig" on WS-CBS3012 resolved the issue.

Regards,

Madhan kumar G

793
Views
0
Helpful
1
Replies