Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ethernet and Fastethernet connection

Hi,

When I issue show log command i saw a lot of the following error message

Nov 28 03:16:57.079 UTC: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on Ethernet0/0 (not full duplex), with GZOFF-24AREA01.china.nokia.com FastEthernet0/4 (full duplex).

Nov 28 03:17:57.086 UTC: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on Ethernet0/0 (not full duplex), with GZOFF-24AREA01.china.nokia.com FastEthernet0/4 (full duplex).

Nov 28 03:18:57.090 UTC: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on Ethernet0/0 (not full duplex), with GZOFF-24AREA01.china.nokia.com FastEthernet0/4 (full duplex).

but when i check my Ethernet 0/0 is actually set to full duplex.

gv-rtr11#show run

interface Ethernet0/0

ip address 172.28.68.2 255.255.255.0

ip access-group WORM_PROTECTION in

ip access-group WORM_PROTECTION out

ip accounting output-packets

load-interval 30

full-duplex

service-policy input marking

traffic-shape group 80 256000 7936 7936 1000

standby 1 ip 172.28.68.1

standby 1 preempt

gv-rtr11#show clo

03:31:43.781 UTC Mon Nov 28 2005

can anyone tell what happen ???

best regards

Lee

  • Network Management
5 REPLIES
Red

Re: Ethernet and Fastethernet connection

What about FastEthernet0/4 on GZOFF-24AREA01.china.nokia.com?

Does it also say "full-duplex" in the config?

New Member

Re: Ethernet and Fastethernet connection

I'm not sure because i don't have access to the switch. but can we trust the error message? since the error message give us the wrong information on the Ethernet0/0, should be full duplex.

according to the error message the Fastethernet0/4 should be in full duplex mode

thanks for your reply

best regards

Lee

Red

Re: Ethernet and Fastethernet connection

I suspect that the other side is not set to full duplex, but possibly auto

Re: Ethernet and Fastethernet connection

Hi

Can you hardcode the duplex to full in the remote fastethernet 0/4 and check for the logs ?

If you are still getting the error logs would suggest to change the duplex in the ethernet0/0 to half and also in fastethernet 0/4 and verify ??

regds

New Member

Re: Ethernet and Fastethernet connection

Fastethernet0/4 already in full deplex mode as stated in the error log

best regards

Lee Yuet Foong

1675
Views
0
Helpful
5
Replies