Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Facing problems in LMS 3.0.1 ( IPM not making graphs / visuals )

Yes. I think i am doing some mistake.

1. i have two switches. both are 6509.

2. i have configured snmp properly and can see them in rme and can do ssh also to them from cisco works

3. in ipm i try to pull reports i says "no data to poll "

4. i have tried configuring collector from source ip of loopback switch A and destination ip of loopback switch B.  but when i try to take reports not coming,

5. Is there any document to refer to exact steps to generate reports,  i think i am missing some step.

ALSO what configuration shall i do ( on switches to make this IPM generate graphs ).

i tried doing some configs on both switches as below (same on both) :

ip sla monitor 1

frequency 60

ip sla monitor schedule forever start now

and above snippet is same on both the boxes ????? what mistake have i done ? how to fix it and how to see the beautiful LATENCY graphs in IPM ????

125
Views
0
Helpful
0
Replies
CreatePlease to create content