Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Failed to get the start-tag! in the configuration...

Hi!

I get the following message when i´m trying to retreive cfg file from a Cisco WS-6513 Version 12.1(19)E1a System Bootstrap, Version 12.1(4r)E BOOTLDR: c6sup2_rp Software (c6sup2_rp-PS-M)"Failed to get the start tag-! in the configuration.Check if the startup-config file is present on the device. Unable to create a socket to..."

Either you do copy running-config startup-config or just wr.

But this doen´t work, you don´t specify where to "put" you cfg file when doing so!? I´m using Ciscoworks (LMS) 2.5.

Does anyone have a clue? We have two other 6500 that works just fine.

Rgds

Mats

1 REPLY
Silver

Re: Failed to get the start-tag! in the configuration...

You are hitting CSCsb10012. This is resolved in RME 4.0.3.

414
Views
0
Helpful
1
Replies
CreatePlease to create content