find err-disabled ports with snmp

[tkocher]

Hi,

I want to find err-disabled ports in our campus with snmp.

unfortunately I only find the following oid 1.3.6.1.4.1.9.9.548.1.3.1.1.2 which is only supported on non modular boxes like the 3560.

is the on modular chassis an oid available to detect err-disabled ports?

Thanks for your responses.

Thorsten

[Joe Clarke]

If the device supports it, you can use portAdditionalOperStatus from the CISCO-STACK-MIB. If the value is 10, then the port is in err-disable state.