Don't think NetConfig will do it (unless I'm missing something), the configuration changes will differ depending on the device, so there will be a large number of different jobs. Anybody got any other ideas?
I resist the "disable CDP on access ports" recommendations as I don't agree with it. For one, It's useful and necessary for any Cisco VOIP deployment. It also is useful to see if someone has plugged in a Cisco switch or plugged one port into another port (I have seen both) in which case it can be used in troubleshooting.
I even have taken to turning on LLDP - especially for customers with Avaya VOIP since Avaya phones announce themselves via LLDP (and it's pretty easy to make servers do so as well).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...