I have simple Flexible Netflow config on 7206 router:
flow exporter EXPORTER
transport udp 2055
flow monitor default
ip flow monitor default input
ip flow monitor default output
It worked good for some time. Then suddenly router stopped netflow export. `show flow exporter statistics` command shows constant values. Logs are clean. I have similar config on 3 Cisco 2811 routers, and it works well.
What can cause problem?
Router is Cisco 7206VXR NPE-G2, IOS is Advanced Security 12.4(15)T7.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...